日本一二三免费区中文字幕|99国内精品一区二区三区|久久人妻丝袜一区二区三区|天堂av一区二区三区在线播放

The working principle of the lamp warm type Yuba is to increase the temperature in the illumination area by the heat radiation of the infrared bulb, so that the temperature rises quickly, the power is small, and the power consumption is small. Because the lamp warm bath is a local heating, the bathroom area is not large, it is more suitable to install the lamp warm bath. Today, GELAN Xiaobian wants to tell everyone about the common faults and maintenance methods of the lamp warm bath Yuba.

1. Yuba motor does not turn

  A. Yuba capacitor has been broken, just replace the capacitor.

  B. The thermal protector is disconnected and will automatically recover after the temperature drops, which is normal.

  C. The motor has been broken. At this time, just replace the motor (repair by maintenance).

  D. Circuit failure, maintenance circuit (repair by maintenance).

2. Yuba bulb does not light (warm light or light does not light)

  A. The line is faulty, causing the Yuba bulb to not light. At this time, the circuit should be repaired.

  B. Yuba bulb has been broken, just replace the Yuba bulb.

  C. Yuba is not in good contact with the lamp holder. At this time, just tighten the Yuba bulb.

3. When the Yuba is used, it is noisy.

  When the Yuba is used, the noise is generally caused by the vibration or deformation of the Yuba wind turbine. At this time, just replace the wind wheel.

4. Yuba PTC does not heat or heat up slowly

  A. The pin is loose or loose, and the pin is inserted.

  B. Circuit failure, maintenance circuit (repair by maintenance).

  C. The thermal protector is disconnected and will automatically recover after the temperature drops, which is normal.

The above four kinds are the common faults of the lamp warm bath, and the corresponding maintenance methods are also briefly introduced. If you still have any questions, you can consult the GELAN technicians.